Specifications

¾ One (1) Field Type ‘M’, 8” barometric damper

¾ One (1) 8”, 24-gauge galvanized sheet metal cap

¾ One (1) CB-1750 Operator’s Manual

¾ Burner oil line and air line components

¾ Miscellaneous bolts and fittings for assembly / installation of the appliance

Note: This is the standard package for the CB-17 50 Central Furnace. This

appliance can be in stalled as a unit heater without ductwork installed, or as a

central furnace with the properly sized ductwork installed. When ducting th e

appliance, you can duct all of the air from o ne side using the en tire 12” x 12”

opening or from two sides by reducing the two openings to 12” x 6” each. No

ductwork shall be placed on the bo ttom discharge opening. (Refer to the CB-1750

Operator’s Manual for the proper static pressure for the sizing of the ductwork).

1.4 CODES AND REGULATIONS:

The installation of this ap pliance shall b e made i n

accordance with the ma nufacturer’s instructions, as well as i n accordance with all

Federal, State, Regional, or Local Laws and / or Regulations acceptable to the Authority

Having Jurisdiction (AHJ) and shall be accomplished only by a qualified, ce rtified, and

competent heating technician experienced in making such installations as per NFPA 31 –

Chapter 4 – Sections 4.3.2 and 4. 3.3 and the Codes and Regulations that are listed i n

Part 1 – Sections 1.4 through 1.4.4 of this bid specification as applicable.

1.4.1 The design, materials and workmanship of the app liance, burner unit, and th e various

other accessories furnished by Cle an Burn,

LLC, as well as the in stallation of the

appliance, shall fully comply with the re quirements of UL Standard 296A (Und erwriter’s

Laboratories File # MH 15393 (N) and / or Underwriter’s Laboratories of Canada File #

CMP217) and NFPA 31 – Chapter 12 – Sections 12.1 through 12.4.3.

1.4.2 The installation shall fully comply with the following NFPA Codes: 30 – Flammable and

Combustible Liquids, 30A – Motor Fuel Dispensing Facilities and Repair Garages, 31 –

Standard for the Installation of Oil-Burning Equipment, 70 – National Electrical Code, 88A

– Standard for Parking Structures, 88B – Standa rd for Repair Garages, and 211 –

Standard for Chim neys, Fireplaces, Vents, and Solid-Fuel Burning Appliances as

applicable.

1.4.3 The installation shall fully comply with the following International Codes: International

Building Code, International Mechanical Code, International Fire Code , and the

International Fuel Gas Code as applicable.

1.4.4 The installation shall fully comply with the followin g CAN / CSA Standard s: (when

installing the appliance in Canada): B139-00 (ap proved October 2001) – Installation

Code for Oil-Burning Equipment, B140.0-M87 (reaffirmed 2001) – General Requirements

for Oil-Burning Equipment, and C22 .1-02 – Canadian Electric Code – P art 1 as

applicable.

1.5 RIGGING AND UNLOADING:

Vendors shall deliver to the site all equipment,

components, and devi ces specified herein. Ri gging and / o r off-loading will be the

responsibility of the purchaser or the purchasers designated agent.