Specifications

7
2.4.11 If the primary safety control fails while in operation but the flame has been established
and proven, the p rimary safety control shall be of a recycling type whi ch will allow the
burner up to three retries for ignition before the control will “lock-out”.
2.4.12 The primary safety control shall be co mpletely wired and tested b y the manufacturer for
this safety function.
2.4.13 Each used-oil burner shall be fully in accord with the requirements of and a pproved by
Underwriter’s Laboratories and Underwriter’s Laboratories of Canada.
2.4.14 The used-oil burner shall be factory fabricated and be complete with the following:
¾ One (1) Single burner / fan ho using assembly with side mounted combustion air
inlets
¾ One (1) Stainless steel flame retention head
¾ One (1) Hinged swing out mounting bracket
¾ One (1) 4-wire power cord disconnect assembly with connector plug and receptacle
¾ One (1) Burner motor with a 1/10
th
hp motor @ 3,000 rpm TENV, DP, PSC, sealed,
ball bearing, ccw-se rotation, N frame, stud mounted, 3.3” diameter motor, with a 7.5
uf (mfd) / 370 vac capacitor
¾ One (1) Integral squirrel cage draft fan
¾ One (1) Set of dual inner /outer combustion draft control plates
¾ One (1) Oil block assembly, heated
¾ One (1) 400 watt block heater, block mounted, thermostat controlled
¾ One (1) 120
o
F block heater-proving switch, surface mounted
¾ One (1) 140
o
F block thermostat, surface mounted
¾ One (1) Air regulator, surface mounted
¾ One (1) Oil solenoid, surface mounted
¾ One (1) Air solenoid, surface mounted
¾ One (1) Centrifugal proving switch, internally motor mounted
¾ One (1) Air pressure proving switch, block mounted
¾ One (1) Carlin # 41000B, 14,000 vac electric igniter
¾ One (1) Carlin # 42230-02, 30 second safety timing, solid-state primary control with
manual reset safety switch
¾ One (1) Honeywell # C-554A cadmium sulfide flame sensor
¾ One (1) Single piece direct spark igniter
¾ One (1) heated nozzle adapter, thermostat controlled.
¾ One (1) L-130 thermostat, nozzle adapter mounted
¾ One (1) 140 watt nozzle heater, nozzle adapter mounted, thermostat controlled
¾ One (1) Delavan 9-5 nozzle
¾ One (1) 0-15 psig oil pressure gauge, burner mounted
¾ One (1) 0-60 psig air pressure gauge, burner mounted\
¾ One (1) Run time hour meter, burner mounted
¾ One (1) Green indicator light for power on indication, burner mounted
¾ One (1) Amber indicator light for oil pump on indication, burner mounted