VE Series Owners Manual
OPERATING YOUR WALL CONTROLS
WWW.CLEANCOMFORT.COM
8
IO-VENT-HG IO-VENT-HG
VHP-RD3D
Deluxe Remote Ventilation Wall Control
Features
• Humidity Sensor Dial to control venlaon operaon
• Compable with Clean Comfort VH30120R and
VH30160R HRVs models only
• Range Control (OFF, NORMAL and REDUCED)
• Mode Control (INTERM, RECIRC and CONT)
• Green LED light on = OVERRIDE
• Orange LED light on = CONT/INTERM
Range Selector Switch (OFF/NORMAL/REDUCED)
• OFF - Turns o the venlaon system
• NORMAL - The venlaon system operates at the
Connuous (CONT) speed set by the installer
• REDUCED - The venlaon system operates at 30%
lower speed when in CONT mode and 15% lower speed
when in OVERRIDE mode
Note: REDUCED mode will not operate below the
minimum low speed of the venlaon system
Mode Selector Switch (INTERM/RECIRC/CONT):
• INTERM - When the selector switch is in the INTERM
posion, the venlaon system will sit idle unl there is
a request for venlaon from a remote wall control. At
this me, the unit will run on high speed unl the relave
humidity is below the set point on the wall control or the
VHP-T3 mer, if installed, has completed its me period.
• RECIRC – Operates the venlator on Recirculaon mode.
The fresh air intake port of the HRV is closed in order
to recirculate the air within the house, prevenng fresh
outdoor air from entering the house through the HRV.
• CONT - Provides connuous venlaon at the
speed set by the installer. The venlaon system will
increase to high speed when the relave humidity is
above the set point on the wall control or the VHP-T3
mer, if installed, has been acvated. This mode is
recommended for best indoor air quality.
VHP-T3
Push Button Timer
Features
• 20/40/60 minutes of venlaon at high speed
• Green LED light on = Venlator is operang in
OVERRIDE (high speed) mode
Operation
• Press the buon unl the LED blinks once and then
release. This operates the venlaon system on high
speed for 20 minutes.
• Press the buon unl the LED blinks twice and then
release. This operates the venlaon system on high
speed for 40 minutes.
• Press the buon unl the LED blinks three mes and
then release. This operates the venlaon system on
high speed for 60 minutes.
• To turn o, press the buon once. This will cancel
the programmed venlaon me period and your
venlaon system will return to previous sengs.
Tip: The VHP-T3 model push buon mer allows the
homeowner to temporarily increase venlaon in the
home to reduce airborne pollutants to or lower the
humidity level.
i CAUTION!
It is normal to experience condensaon on your windows
when there are large swings in indoor or outdoor
temperatures, when excess humidity is generated in
the home (e.g. cooking, showers), or when curtains and
blinds are fully closed.