Technical data

6 MainTenanCe
6.1 SAFETY REGULATIONS
Maintenancemayonlybecarriedoutbyanauthorisedperson.Before
beginningmaintenance,switchofftheunitandsecureagainstinadvertent
switchingon,e.g.by„pullingtheplug“.Workmustbeexecutedalongthe
linesprescribedinChapter1„safetymeasures“.
6.1.1 Maintenance and inspection check list
6.2 GENERAL REMARKS
Donotusecleaningagents,metalobjectsorcompressedair.Dustand
glueresiduesmustberemovedwithascrapermadeofplastic.
Dismantle and clean the tool after use. If not, acid could
concentrate to such a degree that it becomes a health hazard.
The supply of power through the cable could also be affected
and the performance reduced.
Intervals controlposition/adviceofmaintenance utilities
daily,beforeusing Checkthedeviceandthestencil/brush
If necessary replace worn parts
daily, after using cleanstencils,toolhead,cableandstainlesssteelworkingsurface
clean stencils:
carefullybetween2ngersinclearwater
cleaning tool head:
unscrewhandlefromcarbonheadandcleanbothinplentyofwater
attention:
usingawrench,securemandrelonthepumptubing
clean unit and cable:
wipe with a moist cloth
a soft cloth,
brush
16
17
18
19
Operation Manual Clean Marker Brush − Page 17