TPA IMPEX SPA Piazzetta Albere, 3/4 36060 ROMANO D’EZZELINO (Loc. Fellette) - VI - Italy Tel. +39 (0) 424832777 - Fax +39 (0) 424832778 Reg. Imprese di Vicenza - C.F. e P.IVA 01888190244 www.tpaimpex.it The manufacturer reserves the right to make any changes to this user manual without prior notice. Stampa Novaprint - Tel.0424-539449 - www.novaprint.it - COD.
NOTE Read carefully these instructions before using the machine.
1.
LEGEND NOTE CONTROL PANEL **3. A. Main switch with indicator light B. Boiler switch with indicator light C. Vacuum switch D. Low water level light E. Operation indicator LEGEND 1. Transport handle 2. Multi-purpose basket **3 Control panel 4. Detergent tank **5 Control panel 6. Recovery tank 7. Safety cap with water level sensor 8. Water tank 9. Cap **5. F. Steam controller G. Power socket H: Detergent level indicator tank 1 I. Detergent level indicator tank 2 L. Detergent control knob tank 1 M.
15. Information for users B3 According to Directives 2011/65/EU and 2012/19/EU on the reduced use of hazardous substances in electrical and electronic equipment, and their disposal, the barred bin symbol means that at the end of its useful life the product must be disposed of separately from ordinary waste.
Article Article 10 D4221 Article CAUSE The power cord has not been correctly plugged into the power supply outlet. After the boiler has been turned on, The water level in the tank is low. the no water icon on the control pa- The probe cap is loose nel starts to blink and the appliance emits a sound signal. Instruction Manual 7 WINDOW CLEANER GREY VAC/STEAM L=12 BLACK R3 27 27 J7145 J7145 Steam/vacuum kit SOLUTION Plug the power cord plug into the power supply outlet correctly.
3. Important safety instructions READ AND FOLLOW ALL INSTRUCTIONS When using the Cleaning System, always use basic precaution, including the following: WARNING! – To reduce the risk of fire, electrical shock or injury: 1. Do not leave appliance when plugged in. Unplug the Cleaning System from outlet when not in use, or before servicing. Do not allow to be used as a toy. Close attention is necessary when the system is being used around children. Never allow children to use or play with the system. 3.
Cleaning the float When cleaning the bin unit, always check that there is no obstruction of the float or dirt in the float housing. If float cleaning is required, proceed as follows: 1) Turn the knob under the filter anti-clockwise to unscrew it. 2) Remove the polyester filter. 3) While immobilising the top of the bin, open the cage of float (turn it anti-clockwise). 4) Remove the float. 5) Clean the float housing, the float and the float cage. Remove all dirt.
• Put the tanks back in place and reconnect the two water intake fittings. Secure the two clips. • Use the funnel to fill the two tanks with properly diluted detergent. The machine is equipped with two tanks so that two different types of detergent can be used depending on the type of dirt to clean (DET1, DET2) • Close the tank caps. Check the level indicators on both sides of the machine to see how much liquid is in the tanks. . IMPORTANT! Fill the tanks with tap water only.
. General maintenance • Before all maintenance operations, make sure that the power cord is not connected to the mains power supply. • After use of the brushes, to prevent undue deformation, allow the bristles to cool in their normal position. • Periodically check the state of repair of the moulded plug seals (cap.6). If necessary, replace with the spare seals. Periodically check the state of repair of the connection seals of the extension wands and handle.
Vacuum function 5. Accessories holder. To be used with: 5.1 Accessory for liquids and window-cleaning function 5.2 Accessory with bristles for solids IMPORTANT! For the vacuum function to work, switch C on the control panel must be in the ON position (indicator light on). To disable the vacuum function, first press the button B3 on the hand grip and then set switch C, located on the control panel, to the off position. 5.
4. Accessories holder: DRESS-FIT TRIPLE JET Thanks to its specific shape and size characteristics, when used with a special triangular brush, this accessory (4) is particularly suitable for cleaning ovens and worktops. 7. No water When there is no water in the water tank (8), icon (D) on the control panel is enabled (non-blinking mode, then blinking mode, accompanied by sound signal). To proceed with the work, fill once more (see paragraph 5 “FILLING WATER AND DETERGENT TANKS”). 8. Cord reel 4 4.
10. Advice How to use the 2.1 accessory for carpets The side nozzles enable optimal vacuum function at all times and for all uses, even on walls and in corners. Vacuum or steam cleaning are both possible (or these functions combined, only on small surface areas that are not excessively soiled). Do not use on particularly delicate flooring such as parquet, to prevent scratching. Alternatively, the accessory may be used with a cloth attached to the 4 clips. Dry with steam and, lastly, vacuum.