Specifications

Safety, Operation and Maintenance Manual for Parrot (RA 300 E); Version 1.2
6
TO OPERATE AS A SCRUBBER
1. Prepare the floor surface by sweeping or
vacuuming before using the scrubber.
2. Make sure all the switches are OFF.
3. Select the proper floor brushes or pad
drivers and floor pads for the cleaning
operations.
4. Adjust the handle to the best position for
comfortable operation.
5. Fill a clean bucket with clean water, and
pour it into the solution tank opening,
maximum capacity 2.5 gallons.
6. Add the chemical required. Check the
label for dilution rates.
7. Place the solution hose to the far side of
the tank making sure the hose is not bent.
Place the dome to the rear rim of the tank
and press the dome gasket gently into the
front rim.
8. Check to make sure the short solution
hose located at the bottom right on the
scrubber is plugged into the female QDC
connector.
9. When using an external cleaning tool
unplug the hose and plug in the solution
hose to the attachment you are going to
use.
10. Plug in the power cord, turn on the
vacuum switch, and then the brush switch.
11. Start cleaning by squeezing the solution
lever and push the scrubber forward and
reverse.
12. If the floor is very dirty, turn OFF the
vacuum switch. Using the squeegee lever,
lift the squeegee off the floor. Squeeze the
solution lever to add more cleaning
solution to the floor. Scrub the floor
thoroughly.
13. Turn ON the vacuum switch, lower the
squeegee to the floor, and vacuum up the
dirty solution.
14. While cleaning, monitor foam level in the
recovery tank. If heavy foam is building,
pour a quality defoamer into the recovery
tank.
15. Periodically check the solution level in the
tank. NEVER allow brushes or pads to run
dry, otherwise both the pump and the floor
may be damaged.
16. Periodically inspect the squeegee blades
for obstructions (sand, cigarette butts,
paper, etc.), clear, then continue cleaning.
17. Before refilling the solution tank, flush the
recovery tank with clean water.
Handle Height
Adjustment
Handle Angle
Adjustment
Gasket
Short
Solution Hose
Rear Rim
Solution
Lever
DO NOT leave solution in the
bladder. After each use thoroughly
wash out the bladder. This will help
extent the bladder’s life.
IMPORTANT
Squeegee
Lever