Use and Care Manual

10
Vacuum Features
On/Off Switch
NOTE: There are two different on/off switch
configurations depending on the model you own.
Identify your vacuum cleaner model and see the
corresponding on/off switch operating instructions
below.
Model ZM-200 – On/Off switch on base
Locate the switch on the back side of the nozzle to
the left of the handle tube (see Fig. 10). Simply press
the switch with your foot to turn the vacuum on or off.
Do not run the vacuum over the power cord.
Machine should be turned off before returning handle
to full upright position. Always turn the vacuum cleaner
off before unplugging it from the electrical outlet.
Models ZM-400 and ZM-600 – On/Off two speed
switch on handle
The switch for these models, located on the vacuum
handle, is a three-way switch. The middle position is
the “off” setting, the rear position is the “on” setting
and the forward position is for maximum power (see
Figs. 11 & 12).
Use the maximum power setting for carpet cleaning
and the “on” setting for cleaning bare floors and throw
rugs.
Pull the switch backward to turn the vacuum on.
Push the switch halfway back to turn the vacuum
off. Push the switch all the way forward to use the
maximum power setting. Do not run the vacuum over
the power cord.
Machine should be turned off before returning handle
to full upright position. Always turn the vacuum cleaner
off before unplugging it from the electrical outlet.
Fig. 10
Fig. 11
Fig. 12