Use and Care Manual

15
Change the Belt – Model ZM-600
CAUTION: First, unplug the vacuum cleaner
from the electrical outlet.
1. Turn the unit over and remove the
bottom plate (see “How to Remove the
Bottom Plate”).
2. Remove the brushroll and the worn or
broken belt from the brushroll pulley and
the motor drive shaft. (Fig 23)
3. Loop the new belt around the motor
drive shaft and around the brushroll,
making sure the belt is positioned on top
of the motor pulley and not underneath
it. (Fig. 24) Make sure the grooves in the
belt are lined up with the grooves on the
motor drive shaft and the brushroll pulley.
(Fig. 24)
4. Reinstall the brushroll by inserting the
rounded ends of the brushroll into the
housing first. Turn the brushroll by hand
making sure the belt is not twisted and
all rotating parts move smoothly. (Fig. 25)
5. Reinstall the bottom plate (see “How to
Install Bottom Plate”).
NOTE: To ensure maximum cleaning
efficiency, the belt should be checked
regularly to be sure it is in good condition.
Replace the belt if is stretched, cracked or
if excessive slipping is occurring.
Fig. 23
Fig. 24
Fig. 25
How To