Manual

34
Beltpac Buttons C and D Setup:
As shown in the Secondary Buttons area of the button and LED configuration window, you can select the
Mode (Disabled or Momentary) and function for Buttons C and D on each Beltpac.
ISO1 = Talk, to Beltpacs receiving only Tx1 *
ISO2 = Talk, to Beltpacs receiving only Tx2 *
ISO = Talk, to Beltpacs receiving both Tx1 and Tx2
Page = Talk, Page (stage announce)
Aux = Talk, Auxiliary Out
Chan = Toggle Ch1/Ch2
Call = Call Signal
Alert = Alert Signal
* Valid only for dual-receiver Beltpacs.
NOTE: Call Signal only functions when the Talk function is active, and only from a Beltpac to other
Beltpacs which have been preset to produce a tone upon receipt of a call signal.
Buttons C and D modes
• Only Momentary mode can be used. If set for momentary function, button will remain on
only while held. C and D buttons have no lock function
• The button mode can be Disabled (turned off) in Beltpac setup.