CELLCOM® / FREESPEAK® CEL-FS-CHRGR MULTI-BAY CHARGER INSTRUCTION MANUAL
SUMMARY OF LED STATUS – Normal Operation Red LED ON………………………………………Fast charging Green LED ON…………………………………….Trickle charging Charging State and fault conditions are indicated by the status of the Red and Green LEDs of each charging bay SUMMARY OF LED STATUS– Fault Conditions Red LED Flashing…………………………………Short Circuit in battery pack Green LED Flashing…………………………..….Cells in pack will not charge Remove the battery pack and investigate.
INTRODUCTION The CEL-FS-CHRGR can be used to re-charge up to five Cellcom ® or Freespeak ® beltpack battery packs in place of the beltpacks’ internal charging circuit. This allows a beltpack to be used with one battery pack whilst a second battery pack is being charged. Additional battery packs and batteries can be purchased from your Clear-Com supplier. The CEL-FS-CHRGR features intelligent circuitry to prevent overcharging. It optimises charging by fast charging for a period and then trickle charging.
CONTENTS Insert battery pack into charger bay with contacts facing down. . IMPORTANT SAFETY INSTRUCTIONS………………...i INTRODUCTION……………………………………………ii INSTALLATION REQUIREMENTS………………………ii INSTALLATION…………………………………………….ii OPERATION………………………………………………..ii SPECIFICATIONS………………………………………….iv Red LED ON – Fast Charging Green LED ON – Trickle Charging Insert DC Power here iii.
