Owner manual

3.4 Installing the HBP-2X Beltpacks

The HBP-2X Beltpack is a device that you can:

• Wear at your belt using the beltclip.

• Install to a shelf or other flat surface.

• Attach to a pole or other fixed upright position.

For more information, see 2.5.3 HBP-2X beltclip, beltloops and feet (base view)

3.4.1 Power up

The HBP-2X Beltpack is powered from the standard mic cable that connects the device with

the HMS-4X Main Station (see below).

3.4.2 Connecting the HBP-2X Beltpack to the Main Station

To connect the HBP-2X Beltpack to the Main Station:

1) There are two partylines on the Main Station which can each support up to 10 digital

HBP-2X beltpacks. There are two connectors (3-pin XLR, male and female) for each

line.

Connect the cable to the selected connector on the Main Station.

Note: For the location of Lines 1 and 2 (the powerlines) on the Main Station, see

in Figure 2-3: HMS-4X Main Station: rear panel

2) Connect the cable to the beltpack, using one of the two 3-pin XLR connectors (male

and female) on the base / rear of the beltpack.

For example topologies, see 3.1.2 Topologies.

HelixNet Partyline User Guide