Owner manual

29
SECTION 5. TECHNICAL DATA
E U
Base S
Q IPMENT SPECIFICATIONS
tation
GENERAL ⎯
0 to 2483.5 MHz
VDC
cm)
Any 4 can have simultaneous full-duplex communication at one time.
Others would be listen-only until a channel becomes available.
TRANSM
Type: Frequency hopping, spread spectrum
100mW burst
REC
Frequency hopping, spread spectrum
Frequency Range: All, 240
Low, 2401.92 to 2439.94 MHz
High, 2443.39 to 2481.41 MHz
Frequency Response: 200 Hz to 3.5 kHz
Power Requirements: 100-240VAC, 50-60Hz or 12-14
Temperature Range: 32-122°F (0-50°C)
Size: 10.2” x 6.45” x 3.33” (1-RU) (25.91 x 16.38 x 8.46
Weight: 2.35 lbs. (1.07 kg) maximum
# of Beltpacs per Base: 15 can be registered
Front Panel Controls: Power, Register Beltpac, Reset, Unlatch and Clear/Band buttons
LEDs
Front Panel Indicators: Registration Status display, Power and Receive
Antenna Type: External ½ -wave dipole (R-TNC connector)
RX/TX horizontal/vertical diversity
System Distortion: <2%
Communication Security: 64-bit encryption dual-slot diversity
Splash Resistant: IEC529 IP Code 4 (under battery operation only)
ITTER ⎯
Transmit Power:
Modulation Type: Gaussian filtered FSK, TDM
Frequency Stability: 13 ppm
Harmonics/Spurious: Exceeds FCC and ETSI specifications over temperature
EIVER ⎯
Type:
RF Sensitivity: <−90dBm w 10
-3
BER
Frequency Stability: 13 ppm
Distortion: <2%