Instruction manual

Clear-Com Communication Systems
IFB-104 Interface Instruction Manual
2-1
INSTALLATION
To install the IFB-104:
1. Connect the female XLR-3 connectors (J101, J201, J301, and/or
J401) to the program feed(s).
2. Connect the RJ-45 connectors (J102, J202, J302, and/or J402) to a
Matrix frame.
3. Configure the Matrix port through the Eclipse Configuration Software
(ECS), which has declared the IFB-104 as a direct 4-wire port
connection.
4. Connect the XLR-3 male (J103, J203, J303, and/or J403) to an on-
air talent receiver.
5. Move the slide switch to WET if the on-air talent receiver requires
power and to DRY if it doesn’t require power. Use the WET setting
with a Clear-Com talent receiver.
6. Connect power to the appropriate connector on the left of the back
panel.
Following is an illustration of how one panel can be connected to an
on-air talent receiver that requires power using the IFB-104.
Figure 2-1: IFB-104 Connections
MATRIX FRAME
TALENT
RECEIVER
IFB-104
DIRECTOR'S PANEL
TALENT EARPIECE
PROGRAM
DIRECTOR
INSTRUCTIONS
DIRECTOR
INSTRUCTIONS
AND PROGRAM
PROGRAM
DIRECTOR INSTRUCTIONS
MIXING CONSOLE
30 VDC POWER
J101
DRY
WET
J102 J103
J201
J202
DRY
WET
J203
J301
J302
DRY
WET
J303
J401 J402
DRY
WET
J403
J1 J2
• Simple connections
can connect on-air
talent receivers to
Matrix panels.
2