Instruction manual

RM-702 TWO-CHANNEL REMOTE STATION
2-7
• CALL ON TALK A: If the call on talk A switch is set to the on position, a
call signal will be placed on channel A whenever the talk function is
activated. This can be used to activate any call-activated functions available
on other stations.
• CALL ON TALK B: If the call on talk B switch is set to the on position, a
call signal will be placed on channel B whenever the talk function is
activated. This can be used to activate any call-activated functions available
on other stations.
• INTRPT ANNC: If the interrupt announce switch is set to the on position,
pressing the announce button will disconnect the microphone from the
intercom line(s). This will allow announcements to be made without being
heard over the intercom channels.
• INTRPT EXT IFB: When the hot mic output is connected to Clear-Com’s
IFB system and the interrupt external IFB switch is set to the on position,
pressing a key on the IFB system will disconnect the selected headset or
panel microphone from the intercom line(s). This allows the RM-702
microphone to be used to cue talent without affecting intercom line
communication.
• LONG LINE A: If a long cable run on channel A is unavoidable and
approaches 1,000 ft. (305 m) or more, set the long line A option switch to
the on position. The ability to set a sidetone null on channel A depends
upon properly setting this switch.
• LONG LINE B: If a long cable run on channel B is unavoidable and
approaches 1,000 ft. (305 m) or more, set the long line B option switch to
the on position. The ability to set a sidetone null on channel B depends
upon properly setting this switch.
• PROGRAM INTERRUPT A: Interrupts the program audio to channel A
while a call signal is sent on channel A (default).
You can change this option so that a talk signal, rather than call signal,
interrupts the program audio on channel A. You do this by re-setting an
internal jumper. See the next section, “Re-Setting Program Interrupt
Options,” for instructions.
• PROGRAM INTERRUPT B: Interrupts the program audio to channel B
while a call signal is sent on channel B (default).
You can change this option so that a talk signal, rather than a call signal,
interrupts the program audio on channel B. You do this by re-setting an
internal jumper. See the next section, “Re-Setting Program Interrupt
Options,” for instructions.
The RM-702 is shipped from the factory with all DIP switches in the off
position. To enable a function, place that DIP switch in the on
position.