User manual

17
APPENDIX A
PS-20 Quick Start
NOTE: This quick start is to be used to get your PS-20 unit initially set and running. Further configuration may be
needed for more advanced operation.
On the back of the PS-20 unit:
NOTE: On the front of the PS-20 unit, verify the Power Switch in turned off.
1. Connect the supplied power cord to the unit, and then plug the unit into the desired power outlet.
2. Select the mode in which you want the unit to operate, CC (Clear-Com), RTS/4 (RTS 4-channel), or RTS/2 (RTS 2-
channel).
NOTE: For an overview of the channel modes, see Figure 4, “Channel Configuration,” on page 10.
3. Select the Termination Impedance, either 200 Ω or 400 Ω .
4. Using Figure 8 on page 14, configure the external devices you want to use with the PS-20 unit.
5. If using an external audio source you want both channel 1 and channel 2 to hear, connect the device using the PGM IN connection
on the back of the PS-20 unit.
6. Turn the PS-20 on.