User Guide User Manual

Manage Your Modem (continued)

Modem Home Page / Basic / Wi-Fi Tab

Your Modem has the capability to transmit a wi-fi signal, allowing compatible wi-fi-enabled devices to

connect to its wi-fi network. Use this page to change the basic wi-fi settings of the Modem.

 Enable Wi-Fi Interface: Check the box so the Modem transmits a wi-fi signal, creating a wi-fi

network

 Network Name (SSID): Shows the Modem’s wi-fi network name (SSID), which is broadcast by

the CLEAR Spot, to allow wi-fi-enabled devices to identify and connect to it. The default wi-fi

network name is WiFiRSU_xx, where ―xx‖ are the last two digits of the MAC ID, which can be

found on the label on the back of the Modem. The MAC ID also might be referred to as WAN

MAC ID.

 Wi-Fi Password: Shows the wi-fi password needed to access the Modem’s wi-fi network. The

default wi-fi password is comprised of the last eight of the MAC ID, which can be found on the

label on the back of the Modem. The MAC ID also might be referred to as WAN MAC ID.

 Radio Channel: Shows the channel number being used by the Modem Click ―Auto‖ for the

CLEAR Spot automatically to choose the best available channel; or select a specific channel (from

the drop-down box).

Click ―APPLY‖ when you’re ready to change the basic wi-fi settings.

If you don’t want to make any changes to the basic wi-fi settings, click ―CANCEL‖.

The other tabs (Home, Device Status, and Advanced) appear on all screens (tabs) of the Modem

Home Page.

At the bottom of every tab of the Modem Home Page, you can click:

 Logout: To log out of the Modem.

 Reboot: To turn the Modem off and turn it back on.

 Reconnect: To reconnect to the Modem, if you’ve lost your connection.

If you’re using your Modem

and are connected to the

internet, click here to open

the Modem Home Page.