Manual

Innovation /
Innovation Wood
User manual
Page 13  Clearaudio electronic GmbH 2014
5. Service and special instruction
In case of any necessary, service for all Clearaudio products should be done by authorized
personal only.
In case of any repair, the clearaudio Innovation -turntable needs to be send to your nearest
authorized Clearaudio distributor, dealer or directly to the Clearaudio factory.
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Germany
Tel/Phone: [phone]
www.clearaudio.de
www.analogshop.de
[e-mail]
Send / ship the Innovation -turntable always and only in the original packing !!!
Only in the original packing Clearaudio can provide the warranty.
If you repackage the turntable, please make all steps inverted like at installation and set up
(chapter 3).
5.1 Special instruction
To achieve the full Clearaudio warranty (for the Innovation turntable 5 years), it is
necessary that you fill out and send the corresponding part of the warranty
registration card back to Clearaudio, within two weeks after purchase.
Only if the product is returned in it’s original packing Clearaudio can provide the warranty.
Transportation advice:
If any transportation of the Innovation -turntable should be necessary, please always remove
the turntable platter and the shaft holder. Otherwise serious damage can occur!
To avoid any dust coming into the bearing, the bearing hole needs to be covered as well.
If the turntable is not in use, disconnect the unit completely from the power supply by
removing the main plug from the socket.
Every two years you can lubricate the bearing of the turntable platter with the delivered oil.
In this case it is enough to put 1 or 2 drops of the oil into bearing.
Please take special caution to any damages of the power cord. Any damages should be
repaired only by authorized personal.
A damaged power cord must be exchanged immediately!
Caution !
Please use only non alcoholic fluids and only fluids specially used for acrylic, to
clean the Innovation -turntable.
Otherwise damage on the material or the surface can occur!
Don’t use try cloths for cleaning because of the electrostatic charging. Suitable cleaning
fluids will be available at clearaudio (www.analogshop.de) or your Hifi dealer.