Upgrade to Master Owner's manual

Upgrade
Innovation to Master Innovation
User manual
Page 9  clearaudio electronic GmbH 2014
Please pay attention that the exchanged Master Innovation pulley is flush mounted with the
axis of the motor.
Now the upgrade from the Innovation to the Master Innovation is completed and you can
switch over to the set – up of the Master Innovation .
In the user manual for the Master Innovation you will find the packing – list, packing
overview and of course the whole description for the set – up of the Master Innovation.
To make it easier for you, you can also go ahead with the following description:
7.)
In the next step remove carefully the lamination of the sensor on the upper surface of the
turntable chassis.
Please remove the lamination extreme carefully and avoid any soiling and
scratches.
Take the stainless steel sub - platter again carefully with both hands and put it onto the
bearing. The lower side must show to the bearing.
Through a lightly (!!) up and down movement the platter will slip onto the bearing upper
part (pic. 8 and 9).
Please remove the lamination extreme carefully and avoid any soiling and
scratches.
Pulley for Master Innovation
Pic. 7: Set – up of the Master Innovation pulley
Distance is approx. 1,2 mm
Pic. 8: Set – up of the sub - platter
Pic. 9: Set – up of the sub - platter