Upgrade to Master Owner's manual

Upgrade
Innovation to Master Innovation
User manual
Page 12  clearaudio electronic GmbH 2014
11.)
Take the stainless – steel sub – platter out of the box 3 and remove only the protection
sheet, but keep the protection film of the upper side of the sub – platter.
Put the sub – platter very carefully onto the upper part of the bearing (pic. 14a)
Now take the main platter out of the box and set it up onto the upper part of the bearing.
The recess for the label must be faced upwards. Now you can carefully remove the
protection film (pic. 14b).
To avoid any damages on your bearing, the Delrin-platter should have room temperature
before the set up begin (approx. 20 ° Celsius).
Avoid major side forces to avoid any damages to the ceramic bearing!
Pic. 14a: Set – up of the stainlees steel sub - platter
Pic. 14b: Set – up of the main platter
Pic. 15: Finished set - up