Instruction Manual

Master Innovation User manual (set-up)
Page 9  Clearaudio Electronic GmbH 2014
5)
Take the drive bearing out of the box. Please remove the bearing protection film carefully.
Carefully place the bearing onto the bearing axis.
6)
Remove the protection film from the sensor mounted on the turntable chassis. Please do so
extremely carefully to avoid introducing any dirt or scratches.
Carefully take the stainless steel platter out of the box, using both hands. Remove the
protection film from the scale ring on the lower side of the turntable. The lower platter side
with the scale ring must be face down when placing it on the bearing.
Again, please remove the lamination extremely carefully to avoid introducing any dirt or
scratches.
Image 4a: Setting-up the bearing
Image 4b: Setting-up the bearing
Image 5: Montage of the sub-platter with scale ring