User Manual

Performance S
E
User manual
Page 19  clearaudio electronic GmbH 2012
8. Special directions
The clearaudio
Performance SE does not require an extensive maintenance.
If the
Performance SE -turntable is for a longer time not in use, please disconnect the motor
from the mains supply.
Every two years you can lubricate (only if you will recognize speed variations) the bearing of
the turntable platter with the supplied oil. In this case it is enough to put 4 or 5 drops of the
oil onto the bearing shaft.
Don’t use aggressive cleaning fluid for the
Performance SE turntable. A few drops of window
cleaner in a glass of water is fully enough.
Please dry all cleaned parts with a fine cotton kerchief carefully.
Please use for cleaning the acrylic parts only special acrylic cleaning fluids an under no
circumstances spirit or fluids based on alcohol. (Danger of surface damages!)
You will find suitable cleaning fluids either in specialised shops or in the clearaudio online
shop: www.analogshop.de .
Please take special caution to any damages of the power cord.
Any damages should only be repaired only by authorized personal.
A damaged power cord must be exchanged immediately!
To achieve the full clearaudio warranty, it is necessary that you fill out and send the
corresponding part of the warranty registration certificate /card back to clearaudio, within
two weeks after purchase. Only if the product is returned in it’s original packing clearaudio
can provide the warranty.
Transportation advice:
If any transportation of the
Performance SE -turntable should be necessary, please always
remove the turntable platter. Otherwise serious damage can occur!
The bearing hole needs to be covered as well, to avoid any dust coming into the bearing.
Always take of the pulley of the motor unit as well, to prevent the motor shaft from any
damages.