Manual
Statement TT 1
User Manual
Page 8 clearaudio electronic GmbH 2014
Now place the installation gauge (4) for the tonearm base on top of the two cylinders (3)
while all four pins on the bottom of the installation gauge, must fit into the threats machined
into the cylinders. You might have to turn the cylinders for correnty aligning.
Tighten the 2 bolts, with the provided hex key, while holding ( pressing ) the gauge down.
Attention: any misalignment will leat to a problem to place the TT1 tonearm later !
4
3
3
3
3
4
Picture 5: Placing the installation gauge
Picture 6: Placing the installation gauge
Picture 7: Tighten the gauge