User Manual

11
10. To play back recordings on your device, press the
“PLAYBACK” button on the remote control (be sure to load
batteries in it first). For more details on the playback
feature, see page 11.
11. To play back or transfer recordings to your PC or
Mac, remove the USB drive from your HD Capture Box
after stopping the recording. Then plug it into your
computer. Browse the drive and go to the “video” folder.
Tip: Using the Remote Control Properly
When using the remote control, make sure the remote control is
aimed directly at the IR Receiver of the HD Capture Box – see #1 on
the device diagram on page 5. Load 2 AAA batteries (not included)
into the remote control before using it.
Tip: Setting the Aspect Ratio
If you’re recording from an AV or older VGA source, you will likely
need to set the recording aspect ratio to 4:3 to avoid the video looking
stretched in the recording. To do this, press the 4:3 button on the
remote control prior to recording. Later, if you switch to an HDMI
video source, you’ll need to press the 16:9 button to switch back to
widescreen recording mode.
Tip: Switching Between 720p/1080p Recording
When the “REC/STOP” button is BLUE, that means the device is
recording in 1080p quality. When the “REC/STOP” button is GREEN,
that means the device is recording in 720p quality. To switch between
recording qualities, hold down the “REC/STOP” button, or press the
720P/1080P buttons on the remote control.