Manual

Quick Start Guide
ClearCube Technology 8834 Capital of Texas Hwy N Austin, Texas 78759 voice 512 652 3500 www.clearcube.com
QSG_C7130_rev_B.fm — Enter your TB topic here
The C7130 C/Port connects standard desktop peripherals to the user’s
ClearCube PC Blade. When used with an R4300 Chassis, the C7130
provides automatic video tuning to deliver optimal display quality.
CONNECTIONS
After unpacking the C7130 C/Port and
power supply, do the following:
1. Verify that the three color switches on
the bottom of the C7130 are set to the
positions marked F, and that the Video
Sharpness Control is set to the 12 o’clock
position. Adjust these controls if neces-
sary. See the diagram on the back of this
sheet.
2. Connect the desktop peripherals to the
C7130 as indicated, and then attach the
power connectors to the peripherals.
3. Connect the twisted-pair link cable
(CAT5 or similar) from the PC Blade to
the CPU connector on the C7130.
CAUTION: Do not plug a telephone cable or Ethernet cable into the
C7130.
4.
Connect the C/Port power supply module to the power supply con-
nector, and then plug the power supply into the AC power socket. The
blue power indicator on the front of the C/Port will light.
5. Examine the Link Status Indicator LED on the front of the C/Port. It
should be green if connected to a PC Blade that is powered on.
If the LED is not green, verify that the link cable is connected to the
C7130, the Chassis has power, the PC Blade is turned on, and the cor-
rect link cable is plugged into the PC Blade.
6. Set the Blade to the desired resolution and scan rate. For best
results with an LCD monitor, set the monitor to its native resolution and
press its Auto-Adjust button.
A higher quality monitor will provide better video results.
Using the C7130 Blade Reset Button
To restart the Blade, press and hold the C7130 Blade Reset button for
at least two seconds to send a Reset signal to the Blade.
1.
Video Sharpness control 7. PS/2 keyboard port
2. VGA video port 8. PS/2 mouse port
3. CPU link cable connector 9. USB 1.1 ports (2)
4.
Power supply connector 10. Blade Reset button
5. Audio line in 11. Power indicator
6. Audio line out 12. Link Status Indicator LED
1 2 3 4
5 6
7 8 9
10
11 12
CAUTION: Do not attach the C7130
C/Port to a telephone jack or other
powered network connection. This will
permanently damage the C7130 C/Port. This
damage is not covered under the ClearCube
Technology limited warranty.
• Improper connection, mounting, or use of this
product could result in component failure or
undesired interference.
• Allow sufficient space around the C7130
for ventilation. Do not place the unit in any
enclosure that restricts airflow around the
device, or on top of any device that gener-
ates significant heat.
• To ensure regulatory compliance, use only the
power supply included in the shipping carton
with the C7130, or a ClearCube-approved
equivalent.
• Do not force a connector into its socket. Do
not connect to AC power until all other con-
nections are made, including the power
adapter.
• Do not connect or disconnect USB devices or
other peripherals during C/Port or Blade start-
up, or unpredictable results may occur.
Notes
C7130 C/Port