User Manual

ManualsBrandsClearCube ManualsCommunicationCD9822 Cloud

Quick Start Guide

ClearCube Technology, Inc. 3700 W Parmer Lane Austin, Texas 78727 (512) 652-3500 www.clearcube.com

Package Contents Cloud Desktop Overview

(Note: the terms Cloud Desktop and zero client are used

interchangeably in this document.) ClearCube

CD7800 and

CD9800 Series zero clients connect to supported ClearCube

PC blades containing Tera1 or Tera2 host cards and virtual

machines to provide:

• Seven USB ports

• Small form-factor pluggable (SFP) connector accepting

various Ethernet modules or RJ45 connector

• Support for fiber media (100FX and 1000SX) and for

copper media

• Support for up to two independently-configurable monitors

– 2 DVI monitors up to 1920 × 1200

– 1 DVI monitor up to 2560 × 1600 (requires included

DVI-to-dual-link-DVI adapter)

• PC–over–IP™ (PCoIP™) Tera2 processors, delivering

PC video, audio, and USB over an IP network

• HD audio in and out (front) and HD 4.0 audio out (rear)

ClearCube PC blades are typically located in remote data

centers. Blade users connect to a remote blade or VM over

an IP network (of fiber and Ethernet segments) using a

Cloud Desktop. Users connect monitors, a mouse, and other

peripherals to their zero client, enabling them to work on the

blade or VM as if it is a local PC. The connection between

the zero client and the remote device is over PCoIP

protocol. Inside the blade, a Tera1 or Tera2 Dual Host card

manages the PCoIP session.

Cloud Desktop connected to blade or to VM

• CD7800-series or CD9800-series Cloud Desktop

• Cable adapter for dual-link DVI

• Power adapter and cable

•This Quick Start Guide

USB Ports

Client Power &

Indicator

Front

Kensington®

Security Slot

PCoIP Session

Indicator

Audio In

Audio Out

DVI #1 (DVI-D)

USB Ports

SFP or RJ45

Connector

Power Jack

HD Audio Out

DVI #2 (DVI-I)

MAC Address

and Serial Number

Rear

* Media can vary depending on model and SFP module connected to

zero client.

Cloud Desktop with Monitors

and Peripherals

Network Infrastructure

Chassis with

Blades and VMs

Fiber or Copper

* Fiber or Copper

CD7800 and CD9800 Series

Summary of content (3 pages)

PAGE 1
Quick Start Guide CD7800 and CD9800 Series Package Contents Cloud Desktop Overview • CD7800-series or CD9800-series Cloud Desktop • Cable adapter for dual-link DVI • Power adapter and cable • This Quick Start Guide (Note: the terms Cloud Desktop and zero client are used interchangeably in this document.
PAGE 2
Page 2 of 3 Ensuring Client & Host Firmware Compatibility Mandatory Setup & Cooling Requirements ClearCube recommends using the same firmware version on PCoIP devices whenever possible. • Ensure at least 4 inches of space around all zero client edges and at least 2 inches of space above the client. • CD7800 and CD9800 support Teradici firmware 4.0.3 and higher. • Ambient temperature around a client must not exceed 35° C (95° F). • CD7800 and CD9800 do not support connection to Tera1 quad devices.
PAGE 3
Page 3 of 3 4. Connect a USB keyboard and a mouse to the USB ports on the front or on the rear of the zero client. Setting up Zero Clients Perform the following steps to connect peripherals and a network cable zero clients. 1. Power on the remote PC blade containing the host card to which you are going to connect. 2.