User Manual

ClearCube Technology, Inc. 3700 W Parmer Lane Austin, Texas 78727 [phone] www.clearcube.com
G0200158 Rev B, 1.1.01.09.2014
Page 3 of 3
Setting up Zero Clients
Perform the following steps to connect peripherals and a
network cable zero clients.
1. Power on the remote PC blade containing the host card to
which you are going to connect.
2. Connect a monitor cable to each DVI port on the rear of
the zero client:
– If you are using a single monitor, enable the host
driver function on the peer host card and install
Teradici Host Driver software. See Tech Bulletin
TB00274: Configuring Dual-Monitor Systems for
Single-Monitor Use on ClearCube Support for
information.
– If you are using a 2560 × 1600 monitor, connected the
included cable adapter for dual-link DVI to the zero
client and to the monitor.
3. Connect an appropriate network cable to the SFP module
or RJ45 connector located on the rear of the zero client,
and then connect the other end of the cable to the
appropriate network infrastructure device (such as a fiber
network switch, fiber transceiver, or copper equivalent).
4. Connect a USB keyboard and a mouse to the USB ports
on the front or on the rear of the zero client.
5. Connect the AC power adapter to the power cable
(included with the zero client).
6. Connect the power adapter to the rear of the client, and
then plug the power cable into a power outlet. Ensure that
the zero client and the host card are on the same network.
See “Buttons and Indicators” for information about
powering the zero client on and off.
Configuration Steps and Additional Information
See PC-over-IP System User’s Guide and PCoIP Firmware
Support and Compatibility Guide at
www.clearcube.com for
information about zero client deployment, configuration,
and administration. If you are using ClearCube Sentral in
your environment, see Sentral Administrator’s Guide for
information about connection brokering, device
administration, and more.
Web site: www.clearcube.com/support
Email: [e-mail]
Toll-free: [phone]
Phone: [phone]
WEEE Disposal Guidelines
In the European Union, this electronic product is under European Directive (2002/96/EC) WEEE. When this product reaches the end of its useful life
or is no longer used, do not discard it with conventional waste. Recycle this product at an approved, designated recycling or treatment facility. Check
with local authorities for proper disposal instructions. For assistance, contact [e-mail]
.