User's Guide

6.4 Configuring Blades
ClearCube Technology, Inc. 67
Figure 31. OSD interface
6.4 Configuring Blades
The following sections describe blade configuration options.
6.4.1 Blade Video Settings
See “6.4.1 Blade Video Settings” on page 67 for instructions about video configuration.
6.4.2 Enabling Audio on a 64-bit OS
NOTE: The 64-bit audio setting shown below only applies to PCoIP using Teradici firmware
version 4.2.0 and lower.
If you are using a 64-bit operating system on a host, ensure that 64-bit audio is enabled in the host
card’s Web interface. This option is on by default. If the 64-bit audio option is off, you might
experience poor audio or no audio output from your host.
1. Enter the host card’s IP address in a Web browser. See 6.1 “Finding a Device’s IP Address
and MAC Address” on page 56 for information about finding a device’s IP address.