User's Guide

Chapter 6. Configuring Devices, Setting Peers, and Connecting
78 PCoIP System User’s Guide
6.6.3 Unmanaged Static IPs with Direct Connection
In the following table, the PCoIP configuration described in this section is circled in red.
Table 10. Unmanaged, static IP with direct connection
Management
Managed
Environment
Unmanaged
Environment
Network
Topology
Peer Assignment
IP Assignment
CMS
Assignment
SLP
Discovery
Static
Assignment
Shared
DHCP


×
Reserved DHCP



Static IP



Direct
Connection
Static IP
×


You can create a direct connection between a zero client and a host, where the zero client and host
are not connected to a network. You might use this type of PCoIP deployment if, for example:
 There is already a ClearCube deployment using direct connections (such as C/Ports) in
your enterprise.
 If you do not want PCoIP traffic on your corporate network.
NOTE: ClearCube recommends using static IPs in this configuration. Using the zero client’s or
host’s static, fallback IP addresses significantly increases the time for devices to become
available because fallback IP addresses are only available after a timeout period.
The following figure shows the architecture described in this section.
Figure 36. Unmanaged static IPs with direct connection (no network connection)