Products Owner's manual

R-Series Data Center Products User’s Guide Network Planning and Site Preparation • 17
The following figure shows cabling between PCoIP zero clients and blades with
PCoIP host cards. For more information about the cabling, shown in the following
figure, see Table 7, “R4300 Network Module Features: Models 4362 (EP2) and 4363
(EP6),” on page 32.
Figure 14 Cabling Diagram Showing Optional Separation of PCoIP Traffic (Dashed Cabling)
Free IP Address Requirement
With the R4300 chassis, the default startup configuration is DHCP (Dynamic Host
Configuration Protocol), which automatically requests an IP address from your DHCP
server. If you do not have a DHCP server, the R4300 chassis defaults to a static IP
address of 192.168.1.251. If there is no DHCP server in your environment, set the IP
Mode to Fixed IP and assign it a unique IP. This Free IP Address requirement on
R4300 in a Fixed IP mode is same as on R4200 with an installed Remote Management
Card/Controller.
The R4200 chassis with a Remote Management Controller/Card (RMC) does not
support DHCP and is always in Fixed IP mode.
Chassis
Data Center & Blades with PCoIP Host CardsUser Desktops
with PCoIP Clients
Network
Switch
Admin C/Port
and Terminal
Ethernet for
PCoIP Traffic
Ethernet
Ethernet