Products Owner's manual

R-Series Data Center Products User’s Guide Chassis and Blade Installation • 49
The following figure shows the list of configuration parameters.
Figure 29 RMM Parameters via Telnet
3. Enter the command to change a parameter in the format:
cfg ParameterName Value
where ParameterName is the parameter and Value is its desired new value.
4. When finished changing parameters, type
exit to close the Telnet window.
Resetting the RMM Settings to the Factory Defaults
In normal use, the RMM is configured using Sentral. However, it can be reset to its
factory configurations by pressing the DFLT pinhole switch on the back of the RMM.
Table 10 provides the default RMM settings. For information on configuring an RMM
with Sentral, see the Sentral Administrator’s Guide.
Table 10 R4300 RMM Default Configuration Settings
Field Name Function Setting Options Default Setting
IPMode IP Address Mode Static | DHCP DHCP
RMMIP RMM Fixed IP Address Ignored if IP Mode = DHCP 192.168.1.251
RMMNetmask RMM Netmask Ignored if IP Mode = DHCP 255.255.255.0