User Manual

19 UNITE 200: User Guide
AUTO, VISCA protocol Options: 1 - 7
P_D_Address: PELCO-D protocol.
Options: 0-254
P_P_Address: PELCO-P protocol.
Options: 0-31
V_AddrFix: The switch you can
change camera uart address.
Options: On, Off (When set to On,
the 88 30 01 FF command is
invalid.)
Net Mode: Set the serial port control
networking. Options: Serial, Paral
Baudrate: Serial port baud rate.
Options: 2400, 4800, 9600
8. RESTORE DEFAULT
Select Restore Default in the main
menu and press the [HOME] button.
The RESTORE DEFAULT menu
appears, as shown in the following
figure:
Restore: Confirm restore factory
settings. Options: Yes, No
NOTE: Press the [HOME] button to
confirm.
RESTORE DEFAULT
Restore? No
Change Value
[Home] OK
[Menu] Back