User Manual

20 UNITE 200: User Guide
IP FUNCTION
1. Operating Environment
Operating System: Windows
7/8/8.1/10
Note: Using the included utility
programs requires Windows, but
using the Web interface does not
require any particular operating
system.
Network Protocol: TCP/IP
2. Equipment Installation
1) Connect the camera to your
network or to your PC directly via an
Ethernet cable.
Note: To connect the camera directly,
use an Ethernet crossover cable.
2) Turn on the camera.
3) If the orange light of internet port
is on and the green light is flashing,
then the camera is connected to the
network or to your computer.
3. Internet Connection
Ways to connect the camera and a
computer are shown in the figures
below:
Connect directly by Ethernet
crossover cable
Connect via router/switch
4. Access the camera
though LAN.
4.1. Setup IP address
The camera’s default IP address is
192.168.100.88. If you forget the
camera’s IP address or have
changed it, use the method below to
show the camera IP address:
Press * and # and 4 on the remote
control to display the camera IP
address on-screen.
To change the camera’s IP address:
a. Open the camera’s Web interface
(see Access Camera’s Web
Interface later in this Manual for
detailed instructions).
b. On Web interface page, find
“Network”--->Change IP. Enter a