User Manual

29 UNITE 200: User Guide
Troubleshooting
Problem Solution
No image
1. Check whether the power cord is connected, voltage is
OK, POWER lamp is lit.
2. Check whether the camera can self-test after start up.
3. Check the BOTTOM switch and make sure the two
switches are both set OFF.
4. Check the video cable to make sure it is connected
correctly.
Abnormal display of image
Check the video cable to make sure it is connected correctly.
Image dithering even at
widest zoom position
1. Check whether the camera is fixed correctly.
2. Make sure there is nothing nearby causing vibrations.
IE browser not showing
video image
When the camera is accessed the first time by Internet Explorer
(or another web browser), you must install the plug-in. The first
time you use this camera by internet (only for new user), you
must install the player software (VLC). Please go to VLC
website http://www.videolan.org/vlc,download and Install VLC
(player software). After installation, log in again. You should see
the video stream on the home page of the Web interface.
Unable to access IP
Camera by browser
1. Make sure your computer is connected to the network, to
rule out cable failure or network failure caused by a virus. Make
sure you can ping the computer from another machine and that
the computer you’re using can ping other machines on the local
network or the gateway.
2. Disconnect the camera from the network, ensure that the
camera and PC are connected (either directly, using a
crossover cable, or via a router or switch), and then follow the
directions earlier in this guide for resetting the IP address.