Owner manual

CONNECTING THE ACCUMIC
™
PC
© 2004 ClearOne Communications, Inc. All rights reserved. Information in this document subject to change without notice.
800-157-002 Rev. 1.0
ClearOne Communications ~ 1825 Research Way, Salt Lake City, UT 84119 ~ 1-800-945-7730 ~ www.clearone.com
Getting Started Guide
Select and Adjust Far-End Microphone Balance
You must select Microphone in the Recording Control window to ensure audio is being sent
to the far end.
1. Open Volume Control panel.
2. On the Options menu, click Properties.
3. In the Properties window, click Recording.
4. Select the Microphone check box.
5. Click OK to open the Recording Control window.
6. Click the Select check box for Microphone Balance.
7. Use the volume slider to adjust the volume of the audio being sent to the far end.
AccuMic
™
PC
Audio Conferencing
Line In
AccuMic PC
PC Soundcard
10-Pin
Connector
PC or Laptop
Line In/
Spkr In
Line Out/
Spkr Out
Mic In
To Line Out
To Mic In
To Speaker Out
To Power
Speaker
Power Supply
20' Cable
Speaker Ref In
Mic Out
Speaker Ref In
Power Connector
Figure 7. Recording
Figure 8. Recording control
USING THE ACCUMIC
To Mute the AccuMic
1. Press the Mute button (on top of the mic pad) to mute the AccuMic PC mic
elements.The LEDs will turn red.
2. Press Mute again to unmute the mics.The Leds will turn green.
When using two connected AccuMics, pressing the Mute button on either unit will
mute/unmute both AccuMic mic pads.
Figure 1. Connection diagram