User's Manual

For Full Control
Select the new parameter values and click OK to save
changes to the receiver.
Eding Transmier Parameters:
The easiest and most intuive way to set the parameters of ClearOne transmiers and receivers is with ClearOne Remote soware.
Load ClearOne Remote from the disk provided onto a computer running Windows XP or Windows 7 (32 or 64-bit) and connect to the
receiver via USB or RS232. Then open ClearOne Remote and select ONLINE.
Open The Channel Edit Window:
1) The [Click to Edit] funcon opens the edit window of the channel you wish to edit.
2) Select the funcons you want to edit and enter the parameter. (The various funcons are described below.) Click [OK] to save the
changes and close the Channel Edit window.
3) You will noce that the [Needs to Sync] alert is lit. This indicates that one or more parameters are in queue in the receiver ready to
be downloaded and implemented with the next transmier Sync of the channel.
1)
2)
Digital Wireless Microphone Systems
Using the ClearOne remote soware:
Click to Edit the channel’s parameters
3)
The “Need To Sync” alert is lit. Sync the transmier to apply the selected parameters.
ClearOne Remote provides the following funcons:
File:1. Save a PDF image of the screen.
Sengs:2.
Phantom Power:A. Turn antenna phantom power on or o. Default = ON.
Redundancy: B. Set adjacent pairs of receivers to redundancy mode. Default = OFF.
Headphone Mode:C. Toggles the mixed output jack from headphone mode to a balanced line output. Default = Balanced
line output.
Ethernet Sengs: 3. If using Ethernet, assign the proper IP address to the ClearOne Receiver.
RF Scan - RF Plot: 4. Shows the RF strength of each antenna in a ClearOne system and shows if there is outside interference.
Presets: 5. Save or load preset system parameters conguraons. Default = As Ordered.
GPIO:6. Assign contact closure funcons and setup for RS232 control. Default = RS232 - Output mutes.
Security: 7. Password to prevent unauthorized changes: (Under construcon). Default = none.
Alerts: 8. Send alerts to authorized personal when prevenve maintenance is required of if there is a fault. Default = none.
Update System: 9. Checks to see if the system has the most current rmware and provides a wizard for updang the rmware.
Help:10.
Tutorials:A. Seng parameters, Antenna Applicaon Guide, etc.
About: B. Shows vital stascs for each component of the system
Transmier + Last 4 digits of serial Number Default Transmier Preamp Gain
BLT XXXX +10 dB
HH XXXX H18 = 0dB, H13 & H18 = +20dB
PDM XXXX +10dB
BDM XXXX +20dB
Default Transmier Preamp Gain Sengs:
BLT = Beltpack
HH = Handheld Mic
PDM = Podium Mic
BDM = Boundary Mic
Key: