CHAT® 50 Personal Speaker Phone Quick Start Guide
Table of Contents CONFIGURING THE CHAT 50.............................................1 CONNECTING YOUR CHAT 50 ..........................................2 Connecting the CHAT 50 to a PC......................................... 2 CONFIGURING AND TESTING YOUR CHAT 50.................3 CHAT 50 Audio Configuration.............................................. 3 USING THE CHAT 50...........................................................4 CHAT 50 LED Indicators...................................................
QUICK START GUIDE CONFIGURING THE CHAT 50 The CHAT 50 can be used right out of the box and there’s no software to download or install if it is to be used only with a PC. If the CHAT 50 is to be used with any other device or if the CHAT 50 firmware requires updates, follow the instructions in the CHAT 50 User’s Manual to setup and configure the CHAT 50. The latest version of the software and CHAT 50 User’s Manual can be found on the ClearOne Website at: http://www.clearone.
CHAT 50 Group Speaker Phone CONNECTING YOUR CHAT 50 The following describes how to connect your CHAT 50 to a PC. The CHAT 50 can also be connected to a number of other devices. For information on connecting the CHAT 150 to other devices, refer to the CHAT 50 User’s Manual. Connecting the CHAT 50 to a PC Use the included USB 2.0 cable to connect the CHAT 50 to your PC (Figure 1).
QUICK START GUIDE CONFIGURING AND TESTING YOUR CHAT 50 Consult the CHAT 50 User’s Manual for all device and software configuration procedures as needed. CHAT 50 Audio Configuration To ensure optimal sound quality, the CHAT 50 MUST be tuned properly prior to use or after the device has been moved. The CHAT 50’s audio settings must also be customized for the specific application it is to be used with and for the specific device it is to be connected to.
CHAT 50 Group Speaker Phone USING THE CHAT 50 CHAT 50 LED Indicators The three microphone LED indicators illuminate blue when the CHAT 50 microphones are active. The indicators illuminate red when the microphones are muted. The seven volume LED indicators illuminate blue to indicate the current volume setting—more lights indicate higher volume. Volume & Mute Buttons Use the Volume Up/Down buttons (indicated by a large dot and a small dot) to adjust the volume level of the CHAT 50.
QUICK START GUIDE CHAT 50 SPECIFICATIONS AND REQUIREMENTS System Requirements Microsoft Windows XP SP2, Vista, 7 and 8 (All Versions) Technical Specifications USB USB 2.
Caution: Read the Safety Information in the instruction manual Technical Support TELEPHONE 1.800.283.5936 FAX 1.801.974.3669 Email tech.support@clearone.com U.S. PATENTS: D539,274; D556,189; D531,999. OTHER PATENTS PENDING. © 2014 ClearOne, Inc. All rights reserved. Information in this document is subject to change without notice. 800-159-002 Revision 3.
CHAT® 50 个人会议扬声器 快速入门指南
目录表 配置 CHAT 50 .....................................................................1 连接您的 CHAT 50 ..............................................................2 将 CHAT 50 连接到 PC ...................................................... 2 配置和测试您的 CHAT 50 ...................................................3 CHAT 50 音频配置 ............................................................. 3 使用 CHAT 50 .....................................................................4 CHAT 50 LED 指示灯 ...............................
QUICK START GUIDE 配置 CHAT 50 CHAT 50 可以开箱即用。如果仅用于 PC,不必下载或安装任何软件。 如果 CHAT 50 要与任何其他设备一起使用或是 CHAT 50 固件需要更 新,请按照 CHAT 50 用户手册中的说明来设置和配置 CHAT 50。 CHAT 50 用户手册和最新版本软件可以在 ClearOne 公司网站上找到: http://www.clearone.
QUICK START GUIDE 连接您的 CHAT 50 下面描述了如何将您的 CHAT 50 连接到 PC 上。 CHAT 50 还可以连接到许多其他设备。如想将 CHAT 150 连接到其他设 备,请参阅 CHAT 50 用户手册。 将 CHAT 50 连接到 PC 使用附带的 USB 2.
CHAT 50 Group Speaker Phone 配置和测试您的 CHAT 50 所有设备和软件所需的配置过程可查阅 CHAT 50 用户手册。 CHAT 50 音频配置 为了保证最佳的音质,CHAT 50 必须在使用之前或是在设备被移动之后 进行恰当的调整。CHAT 50 的音频设置也必需要为使用的特定应用程序 或是连接的特定设备而定制。 如果 CHAT 50 是直接连接到一台 PC 或通过第三方应用程序(如Skype 等)设置来连接,扬声器的音频设置便源于 Windows 的声音设置。请参 阅CHAT 50 用户手册中的优化声音质量章节或咨询具体的第三方应用程 序优化调整。 为了进一步了解如何配置各种设备来适应 CHAT 50 的音频设置,请参考 CHAT 50 用户手册。 3
QUICK START GUIDE 使用 CHAT 50 CHAT 50 LED 指示灯 当 CHAT 50 的麦克风处于激活状态时,麦克风 LED 指示灯会亮起三个 蓝灯。当麦克风静音时,这些指标灯会亮起红灯。 七个音量 LED 指示灯亮起蓝灯时表明当前的音量设置,音量越高则亮的 灯越多。 音量和静音按钮 使用音量升/降按钮来调整 CHAT 50 的音量级别(按钮分别用一个大圆 点和一个小圆点来标识)。长按住按钮会迅速改变音量。 使用静音按钮可以使 CHAT 50 的麦克风静音,再次按静音按钮可取消 静音。如果您正在通过一台 PC 机使用 CHAT 50,您可以使用 Windows 中的扬声器音量控制,也可以通过 CHAT 50 软件来调整音量和使麦克 风静音。 4
CHAT 50 Group Speaker Phone CHAT 50 规格和要求 系统需求 Microsoft Windows XP SP2, Vista, 7 和 8(所有版本) 技术规范 USB USB 2.
注意:请阅读使用手册中的安全信息 技术支持 电话 1.800.283.5936 传真 1.801.974.3669 电邮 tech.support@clearone.com 美国专利: D539,274; D556,189; D531,999. 其他专利待批。 © 2014 ClearOne, Inc. 版权所有。 本文档中的信息如有更改,恕不另行通知。800-159-002 版本 3.