Instruction Manual

Appendix C: Specifications 261
CONVERGE SR 1212
Audio Performance
Conditions: Unless otherwise specified, all
measurements are performed with a 20 Hz to 22 kHz
BW limit (no weighting)
Frequency Response: 20 Hz to 22 kHz ±1dB
Noise (EIN): -126 dBu, 22 kHz BW, max gain,
Rs=150 Ω
THD+N: <0.02%
Dynamic Range: 100 dB (non A-weighted)
Crosstalk <-91 dB re 20 dBu @ 20 kHz channel to
channel
Auto Mixer Features
Number of Open Microphones (NOM)
PA Adaptive Mode
First Mic Priority Mode
Last Mic Mode
Maximum # of Mics Mode
Ambient Level
Gate Threshold Adjust
Off Attenuation Adjust
Hold Time
Decay Rate
Matrix Mixing Features
36x36 matrix
12 analog in/out
12 expansion bus in/out
8 assignable processing blocks in/out
4 assignable fader blocks in/out
Assignable Processing Blocks
Filters
All pass
Low pass
High pass
Low shelving
High shelving
Parametric EQ
Notch
CD Horn
Crossovers
Bessel
Butterworth
Linkwitz-Riley
Compressor
Delay; adjustable up to 250 ms
Assignable Fader Blocks
Gain/Mute
Microphone Input Configuration
Input Gain Adjust
Mic or Line Level
Phantom Power on/off
Filters
All Pass
Low Pass
High Pass
Notch
PEQ
Mute on/off
Chairman Override on/off
AGC on/off
Automatic Level Control on/off
Auto Gate/Manual gate
Adaptive Ambient on/off
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
»
»
»
»
»
»
»
»
•
»
»
»
•
•
•
•
•
•
•
»
»
»
»
»
•
•
•
•
•
•
Mic/Line Inputs 1-8
Push-on mini-terminal block, balanced, bridging
Impedance: < 5 KΩ
Nominal Level: adjustable -56 dBu to 0 dBu (7 dB step
coarse gain adjustment)
Maximum Level: -65 dBu to +20 dBu
Phantom Power: 24 V, selectable
Line Inputs 9-12
Push-on mini-terminal block, balanced, bridging
Impedance: < 5 KΩ
Nominal Level: 0 dBu
Maximum Level: 20 dBu
Outputs 1-12
Push-on mini-terminal block, balanced
Impedance: < 50 Ω
Nominal Level: 0 dBu
Maximum Level: 20 dBu
Expansion Bus In/Out
Proprietary Network
RJ-45 (2), 1.9 Mbps
Category 5 twisted-pair cable, 200’ maximum cable
length between any two Converge/Converge Pro
devices
Ethernet
Autoswitching with Quality of Connection (QoC)
10/100 Mbps Ethernet Network Port
10/100 Mbps Ethernet PC Port
RJ-45 Connectors
RS-232
Serial Command Protocol Only (Console software not
supported on RS- 232 port)
DB-9 female
9,600/19,200/38,400/57,600/115,200 baud rate; 8 bits,
1 stop bit, no parity
Hardware flow control on (default)/off
USB
Version 2.0 compatible
Type: B-connector
Control/Status Ports
DB-25 female A/B (2)
Inputs A/B: active low (pull to ground)
Outputs A/B: open collector, 40 VDC max, 40 mA each
+3.3 VDC pins (2) (300 mA over-current protected)
Configuration & Administration Software
Converge Console
Power Input Range
Auto-Adjusting
100–240 VAC; 50/60 Hz
Power Consumption
30 W Typical
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•