Specifications

9 www.clearone.com
Converge 880TA Rear Panel
Rear Panel Connectors
AC Power1. : IEC connector, 100 – 240VAC auto-adjusting, 50/60Hz.
Mic/Line Inputs2. : Mini-terminal push-on connector for connecting any combination of microphone and/or line
level inputs. (880: 8 inputs. 880T: 8inputs; 840T: 4 inputs. 8i: 8 inputs. TH20: 0 inputs. SR 1212: 8 inputs.)
Line Outputs3. : Mini-terminal push-on connector for line-level outputs (880, 880T, 840T, SR 1212).
Line Inputs4. : Mini-terminal push-on block connector for line-level inputs only. (880: 4 inputs. 880T: 4 inputs. 840T:
4 inputs. 8i: 4 inputs. TH20: 2 inputs. SR 1212: 4 inputs.)
Line Outputs5. : Mini-terminal push-on block connector for line-level outputs (880, 880T, 840T, TH20, SR 1212).
Link In and Link Out Ports6. : Two RJ-45 E-bus (expansion bus) connectors used to connect multiple units
together to create a site. You can connect up to eight Converge Pro 880, 880T, 840T, 8i or Converge SR 1212
units, up to 16 Converge Pro TH20 units, or any combination thereof where the total number of microphone inputs
does not exceed 64. Maximum cable length is 200 feet using CAT 5 twisted pair cable.
WARNING: Use the Link In and Link Out ports with Converge/Converge Pro devices ONLY.
Connecting ANY other devices to the Link In and Link Out ports, including ClearOne XAP or
PSR1212 products, or Power Over Ethernet (PoE) devices, will result in severe equipment dam-
age.
RS-232 Serial Port7. : Female DB9 connector for connecting to a laptop, computer, or remote control serial
devices (such as AMX and Crestron controllers).
NOTE: Converge Console software cannot connect via the RS-232 port; use USB or Ethernet.
Control/Status A and B Ports8. : Two female DB25 connectors used for GPIO interactions between Converge/
Converge Pro devices and external control devices (such as wall switches and push-to-talk microphones). This
enables external devices and controller software to access the Converge/Converge Pro serial command set,
including common functions such as volume control, muting, room combining, and preset changes.
PC and LAN Ethernet Ports9. : Two RJ-45 10/100Mbps auto-sensing Ethernet ports. The PC port provides a pass-
through network connection for use with a standard (not crossover) patch cable. The LEDs adjacent to each port
indicate connection status and packet traffic activity.
Speaker Posts10. :Twopost/bananaplugconnectorsusedtoconnectanexternalspeaker(4Ω–16Ω).Aninternal
10W power amplifier eliminates the need for an external power amplifier (880T, 840T).
Telco Line and Telco Set Ports11. : Two RJ-11 telephone ports. The Telco Line port provides an analog connection
to a telephone network. The Telco Set port provides a pass-through connection for telephone handsets.
LINE IN
LINE OUT
5678
1
10
11
234
6
7
8
9
12341234
5678
5678
,
R
12