Specifications

Technical Services: 800-283-5936 191
NOTE: Use auto sweep to test the frequency response of a room and speakers, and to identify
distortion or rattles produced by the speakers or speaker housings. Auto sweep moves
the frequency of the signal generator from a low frequency to a high frequency at the
specified rate. The Frequency slide control and readout reflect progress while the sweep
is in progress. Sweep range is 20Hz—20kHz; increment range is 10Hz—20kHz, and the
rate range is 10ms—2000ms. The default rate is 100ms.
3. Press the Signal On button to generate the tone test signal, or press the Auto Sweep button to initiate an
auto sweep.
System Checks Tab
System Checks performs the network, telephone, and mic diagnostic tests selected on the System Check
Config Tab, then displays the results on-screen.
The test LEDs indicate test results as follows:
Red = Test fails
Yellow = Test not enabled in System Check Config
Green = Test passes
•
•
•