Specifications

236 Appendix A: Serial Commands
Argument Details
Name Type Size Values
System
Check
Hexadecimal
Integer
4 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
│ │ │ │ │ │ │ │ │ │ │ │ │ │ │ │
│ │ │ │ │ │ │ │ │ │ │ │ │ │ │ └── Network
│ │ │ │ │ │ │ │ │ │ │ │ │ │ └── Telephone
│ │ │ │ │ │ │ │ │ │ │ │ │ └── Mic 1
│ │ │ │ │ │ │ │ │ │ │ │ └── Mic 2
│ │ │ │ │ │ │ │ │ │ │ └── Mic 3
│ │ │ │ │ │ │ │ │ │ └── Mic 4
│ │ │ │ │ │ │ │ │ └── Mic 5
│ │ │ │ │ │ │ │ └── Mic 6
│ │ │ │ │ │ │ └── Mic 7
│ │ │ │ │ │ └── Mic 8
All other bits reserved.
SYSRESULT – SYSTEM CHECK RESULT
This command reports the results of the system check. This command is reportable only. It cannot be queried or
set.
The bits in “System Check” signify which test result is being reported. Each test results in a separate SYSRESULT
message.
Argument Details
Name Type Values
System
Check
Hexadecimal
Integer
4 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
               
               └─ Network
              └ Telephone
             └ Mic 1
            └ Mic 2
           └ Mic 3
          └ Mic 4
         └ Mic 5
        └ Mic 6
       └ Mic 7
      └ Mic 8
All other bits reserved.
Status Unsigned
Integer
2 0 = Fail
1 = Pass
2 = NULL <Not Tested or Test Disabled in SYSCONFIG>
String 40 For the telephone on hook: the message will report the line voltage, the line current,
other results, and if dial tone is detected.
For the telephone off hook: the message will report the line current, other results,
and if dial tone is detected.
The bit mask for the other results is
xxxx xxxx
| | | | | | | |--> set if switched from CTR21 to FCC because of low current
| | | | | | |--> set if used DIAL bit while dialing
| | | | | |--> set if switch from Low Voltage to Japan because of current
| | | | |--> set if switch from Low Voltage to FCC because of current
| | | |--> DAA OVL status
| | |--> DAA DOD status
| |--> DAA OPD status
|--> Not used
For the network check: the box will report if no IP address is set. If it is set, the box
will ping the gateway. The message will say the ping failed if it is not returned in 5
s. Otherwise, the message will report how many seconds it took to return the ping.
TAMODE - TELCO ADAPT MODE
This command selects/reports the Telco adapt mode.