Specifications

Technical Services: 800-283-5936 47
maintained by the Converge Pro unit connected to a control device through its RS-232 Serial Port, in this case the
third unit in the network which is also designated as the first Audio Master in the network.
NOTE: A master unit is not required in Converge Pro networks, and in most installations, all units
will be slaves.
NOTE: SNMP Control is not affected by Audio Master designations.
For information about the Link In Link Out connections used to build Converge Pro networks, see Controls &
Connections.
Room
Enter a descriptive name for the room in the Room field.
Default Meter & Channel
Select an input, output, or processing channel to be the Default Meter on the front panel LED Meter when a
channel is not specifically selected.
Telephone Country Code
Select the appropriate Telephone Country Code for your installation (840T and TH20 models only).
Unit Properties: Comm (Communications) Tab
The Comm tab contains IP protocol selection and address settings, as well as serial port configuration settings as
shown below.