Specifications

86 Chapter 3: Converge® Console Programming
Dial Tone Level Slider
The Dial Tone Level slider allows you to set dial tone gain using the slider or selector box. Default is zero. Range is
-12dB to 12dB in 1dB increments.
Recv Boost Slider
The Receive Boost slider allows you to set the gain for the incoming telco rx signal. This is typically used for low-
level telephone lines, allowing the signal to be boosted to an acceptable level of performance. To use Receive
Boost, check the Recv Boost check box, then move the slider to the desired gain settings.
Recv Boost adds up to 12dB of gain to the signal (adjustable in 3dB increments from 0dB to 12dB). The Default is
Off.
Recv Input Meter
The Receive Input meter displays the dB level of the incoming telco signal prior to any post-telco signal
processing.
NOTE: All meters in Console are peak-level meters.
NC Button
Clicking the Noise Cancellation button opens the Channel Property Configuration: Telco RX window with the
NC tab selected, allowing you to configure noise cancellation settings.