Specifications

88 Chapter 3: Converge® Console Programming
Gain Slider
The Gain slider changes the gain for the telco receive channel from nominal 0. To change the value, use the slider
or selector box. Range is from -65 to +20dB in .5dB increments. The default is 0dB.
Post-Gain Meter
The Post Gain level meter displays the post-gain signal level in dB.
Channel Routing Matrtix
The channel routing matrix section of the Channel View screen shows the associated matrix row and audio routing
configuration for the selected input channel (telco rx in this case). Clicking a cross point box selects it, clicking
it a second time sets the cross point, as indicated by a green box. The dB level for set cross points is shown
numerically in the box.
For Telco RX channels, Outputs 5-8, Speaker, and To Exp. Bus S are selected as cross points by default. You
can click directly on any cross point box in the top row to a cross point (routing path), or leave it blank, as required
for your installation.
To adjust cross-point gain/attenuation, right-click on a cross point box and select Cross Point from the pop-up
menu.