User's Manual
Table Of Contents
- _gen_
- Important Safety Information
- INTERACT Software Overview
- INTERACT MIC EX
- INTERACT Dialers
- INTERACT Com / COM-W (Wireless)
- Network Connection
- Phonebook
- Regional Settings
- Event Log
- System Checks
- Firmware Loader
- INTERACT COM Updater
- Serial Commands
- INTERACT AT
- Basic Connections
- Device Toolbox - INTERACT AT
- Mixer Console - INTERACT AT
- Line Input Settings - INTERACT AT
- Line Output Settings -- Interact AT
- Camera Control
- Dialer - INTERACT AT
- Communications Settings - INTERACT AT
- Record Output Settings -- INTERACT AT
- INTERACT Mic and Mic EX Settings - INTERACT AT Only
- Playback Input Settings - INTERACT AT
- Telephone Settings - INTERACT AT
- Loudspeaker Settings - INTERACT AT
- INTERACT COM Settings - INTERACT AT
- INTERACT PRO
- INTERACT PRO 8i
- Device Toolbox - INTERACT PRO
- Mic Settings - INTERACT PRO
- Mixer Console - INTERACT PRO
- Line Input Settings - INTERACT PRO
- Presets - INTERACT PRO
- Dialer - INTERACT PRO
- Communications Settings - INTERACT PRO
- COM Settings - INTERACT PRO
- Telcos - INTERACT PRO
- Processing Settings - INTERACT PRO
- Output Settings - INTERACT PRO
- Compliance
- Bookmarks
INTERACT AT
The ClearOne INTERACT AT is a mixer that interfaces with the MIC and MIC EX via an RJ-45 cable.
It is equipped with two line inputs, 2 line outputs, a 5-watt amplifier and telephone hybrid.
Features of the INTERACT AT include:
Front
A. On/Off hook indicator
B. Microphone Indicator: Indicators show which microphone channels are active
C. Input Metering: Shows current input level
D. USB 1.1 Compatible Input
Back
A. Telephone Interface: Connect an analog phone line to the INTERACT
B. RS-232 Control Port: Used to connect to the INTERACT Software or control from a 3rd part
controller such as AMX or Crestron
C. Camera Control: Video System Control Architecture port used to control a VISCAcompatible
camera
D. Ethernet Port: 10/100 Mbps Ethernet port. The LEDs adjacent to the port indicate connection
status and packet traffic activity.
E. MIC Pod Input: Input for the INTERACTMIC Pod accessory ONLY!
F. Playback/Record Input/Outputs: Left and right channel input and output RCAjacks used to
connect playback and recording devices
G. Line Input/Output: Mono line input and output RCA jacks
H. Speaker Outputs: Left and right push terminals, 5 watts/channel, 8 ohms
I. Power Adapter Input: 12 V DC 1.25 amp
WARNING: Use the Link In and Link Out ports with INTERACT Devices ONLY.
Connecting ANY other devices to the Link In and Link Out ports, including ClearOne
Converge and Converge Pro products, or Power Over Ethernet (PoE) devices, will
result in severe equipment damage.
- 19 -