User's Manual
Table Of Contents
- _gen_
- Important Safety Information
- INTERACT Software Overview
- INTERACT MIC EX
- INTERACT Dialers
- INTERACT Com / COM-W (Wireless)
- Network Connection
- Phonebook
- Regional Settings
- Event Log
- System Checks
- Firmware Loader
- INTERACT COM Updater
- Serial Commands
- INTERACT AT
- Basic Connections
- Device Toolbox - INTERACT AT
- Mixer Console - INTERACT AT
- Line Input Settings - INTERACT AT
- Line Output Settings -- Interact AT
- Camera Control
- Dialer - INTERACT AT
- Communications Settings - INTERACT AT
- Record Output Settings -- INTERACT AT
- INTERACT Mic and Mic EX Settings - INTERACT AT Only
- Playback Input Settings - INTERACT AT
- Telephone Settings - INTERACT AT
- Loudspeaker Settings - INTERACT AT
- INTERACT COM Settings - INTERACT AT
- INTERACT PRO
- INTERACT PRO 8i
- Device Toolbox - INTERACT PRO
- Mic Settings - INTERACT PRO
- Mixer Console - INTERACT PRO
- Line Input Settings - INTERACT PRO
- Presets - INTERACT PRO
- Dialer - INTERACT PRO
- Communications Settings - INTERACT PRO
- COM Settings - INTERACT PRO
- Telcos - INTERACT PRO
- Processing Settings - INTERACT PRO
- Output Settings - INTERACT PRO
- Compliance
- Bookmarks
Auxiliary Devices (INTERACTAT)
The mixer allows connection to a number of different audio and video peripherals, such as video
codecs, VCRs, DVD players, cameras and computers.
Connecting Video Codecs, Amplifiers and Sound Cards
Line input/output devices such as video codecs, amplifiers and sound cards can be connected to
the Line In or Line Out connectors on the INTERACT mixer. These connectors provide mono-audio.
To Connect a Video Codec
1. Using an RCA cable, connect the Line In on the INTERACT mixer to the line out on a video
codec.
2. Using an RCA cable, connect the Line Out on the INTERACT mixer to the line in on a video
codec.
To Connect a Sound Card
l Using an RCA cable, connect the Line Out or Record Out on the INTERACT mixer to the
line in on an amplifier.
Note: Use the INTERACT software to adjust the equalization and volume of these
devices. Refer to pages 39–46 for more information. When using the INTERACT
software, be sure to drag the amplifier to the correct device (either line out or
record). This will properly assign the AEC reference and change the volume
command on the controller to control the external amplifier volume.
Connecting VCRs and DVD Players
You can record your audio/video conference or play audio using a playback device such as a VCR
or DVD player.
1. For recording, connect the Left and Right Audio Out on the INTERACT to the left and right
audio in on the VCR or DVD player.
2. For playback, connect the Left and Right Audio In on the INTERACT to the left and right
audio out on the VCR or DVD player.
Connecting PTZ Cameras
The Converge system provides voice-tracking capabilities through VISCA control port connection
to a Pan, Tilt, Zoom camera. Voice Tracking allows the camera to move to preset position based
on microphone activation.
l Connect the camera to the Camera Control port on the mixer.
Serial Control Connection
You can connect a computer or a control device, such as an AMX or Crestron, to the INTERACT
mixer through the serial control port. See page 83 for a list of the serial commands.
l Connect computer to the RS-232 Control port on the back of the mixer using a 9-pin
straight-through serial cable.
USB Control Connection
You can also connect a computer to the INTERACT through the USB port.
l Connect computer to the USB port on the front of the mixer using a USB cable.
- 22 -