User's Manual

LINE INPUT SETTINGS - INTERACT AT
The Line Input Settings window is used to customize and configure the audio from the auxiliary
device that is connected to the Line In jack on the INTERACT mixer. Line Input devices include
video codecs, CD players and sound cards.
Note: Many of the most common Line Input devices have been pre-configured for
optimal performance with the INTERACT system. These devices are listed in the
Device Toolbox.
Adding A Device Label
l You can add the Manufacturer and Model of your connected Playback device using a serial
command.
l You can also add your Playback device to the Device Toolbox using the Device Toolbox
Editor, which allows you to specify the Manufacturer and Model.
Equalization
Using Equalizers
l Increase and decrease the Low, Mid and High frequencies using the Equalization sliders.
Levels can be adjusted from +12 dB to – 12 dB.
Learn about Equalization
l Equalization in INTERACT Software is very similar to bass and treble adjustments on a
stereo. Increasing or decreasing the different frequencies allows you to customize loud-
speaker audio and provide the optimal listening experience for your users. Using this feature
is optional.
Mute
Press the Mute button to silence audio on the Line Input.
Meters and Volume
Adjusting Volume
1. Get an audio signal from the line input device.
2. Adjust the audio level using the Volume slider.
Learn about using Meters
l The peak meters are used to measure the audio level with the meter bars moving from green
to yellow to red as the volume increases. The red bars indicate that the audio is too loud and
is being clipped or cut off.
- 26 -