User's Manual

LINE OUTPUT SETTINGS -- INTERACT AT
The Line Output Settings window is used to customize and configure the audio being sent to the
auxiliary device that is connected to the Line Out jack on the INTERACT mixer. Line Output devices
include video codecs, CD players, amplifiers and sound cards.
Note: Many of the most common Line Output devices have been pre-configured for
optimal performance with the INTERACT system. These devices are listed in the
Device Toolbox.
Adding a Device Label
l You can add the Manufacturer and Model of your connected Playback device using a serial
command.
l You can also add your Playback device to the Device Toolbox using the Device Toolbox
Editor, which allows you to specify the Manufacturer and Model.
Equalization
Using Equalizers
l Increase and decrease the Low, Mid and High frequencies using the Equalization sliders.
Levels can be adjusted from +12 dB to – 12 dB (INTERACT AT only).
Learn about Equalization
l Equalization in INTERACT Software is very similar to bass and treble adjustments on a
stereo. Increasing or decreasing the different frequencies allows you to customize loud-
speaker audio and provide the optimal listening experience for your users. Using this feature
is optional.
Meters and Volume
Adjusting Meters
1. Get an audio signal from the line output device.
2. Adjust the Volume using the Volume slider.
Learn about using Meters
l The meters are peak meters measuring the audio level. The meter bars move from green to
yellow to red as the volume increases. The red bars indicate that the audio is too loud and is
being clipped or cut off.
- 27 -