User's Manual
Table Of Contents
- _gen_
- Important Safety Information
- INTERACT Software Overview
- INTERACT MIC EX
- INTERACT Dialers
- INTERACT Com / COM-W (Wireless)
- Network Connection
- Phonebook
- Regional Settings
- Event Log
- System Checks
- Firmware Loader
- INTERACT COM Updater
- Serial Commands
- INTERACT AT
- Basic Connections
- Device Toolbox - INTERACT AT
- Mixer Console - INTERACT AT
- Line Input Settings - INTERACT AT
- Line Output Settings -- Interact AT
- Camera Control
- Dialer - INTERACT AT
- Communications Settings - INTERACT AT
- Record Output Settings -- INTERACT AT
- INTERACT Mic and Mic EX Settings - INTERACT AT Only
- Playback Input Settings - INTERACT AT
- Telephone Settings - INTERACT AT
- Loudspeaker Settings - INTERACT AT
- INTERACT COM Settings - INTERACT AT
- INTERACT PRO
- INTERACT PRO 8i
- Device Toolbox - INTERACT PRO
- Mic Settings - INTERACT PRO
- Mixer Console - INTERACT PRO
- Line Input Settings - INTERACT PRO
- Presets - INTERACT PRO
- Dialer - INTERACT PRO
- Communications Settings - INTERACT PRO
- COM Settings - INTERACT PRO
- Telcos - INTERACT PRO
- Processing Settings - INTERACT PRO
- Output Settings - INTERACT PRO
- Compliance
- Bookmarks
CAMERA CONTROL
The INTERACT system provides voice tracking capabilities through VISCA control port connection
to a PTZ camera. The camera presets are programmed in INTERACT Software and assigned to
each microphone pod. The INTERACT AT supports nine camera positions and a home position.
Camera Control Settings
To open the Camera Control window
l With the camera connected, click the Camera Controls button on the configuration window.
To set camera presets
1. Select the Camera Control Mode, either Sony or Cannon.
2. If you have more than one camera, select which camera you are programming.
3. Select the Camera Delay. Camera delay is the amount of time the microphone must be acti-
vated before the camera moves to the preset position.
4. Select Voice Tracking System Enabled.
5. Using the directional arrow buttons and the Zoom In and Out buttons, position the camera
for the first microphone pod.
6. Click Save Preset under the microphone pod to assign the camera position to the micro-
phone.
7. Repeat steps for the second and third microphones.
To test camera presets
l Click Run Preset to test the preset programming for the microphone pod.
- 28 -