User's Manual
Table Of Contents
- _gen_
- Important Safety Information
- INTERACT Software Overview
- INTERACT MIC EX
- INTERACT Dialers
- INTERACT Com / COM-W (Wireless)
- Network Connection
- Phonebook
- Regional Settings
- Event Log
- System Checks
- Firmware Loader
- INTERACT COM Updater
- Serial Commands
- INTERACT AT
- Basic Connections
- Device Toolbox - INTERACT AT
- Mixer Console - INTERACT AT
- Line Input Settings - INTERACT AT
- Line Output Settings -- Interact AT
- Camera Control
- Dialer - INTERACT AT
- Communications Settings - INTERACT AT
- Record Output Settings -- INTERACT AT
- INTERACT Mic and Mic EX Settings - INTERACT AT Only
- Playback Input Settings - INTERACT AT
- Telephone Settings - INTERACT AT
- Loudspeaker Settings - INTERACT AT
- INTERACT COM Settings - INTERACT AT
- INTERACT PRO
- INTERACT PRO 8i
- Device Toolbox - INTERACT PRO
- Mic Settings - INTERACT PRO
- Mixer Console - INTERACT PRO
- Line Input Settings - INTERACT PRO
- Presets - INTERACT PRO
- Dialer - INTERACT PRO
- Communications Settings - INTERACT PRO
- COM Settings - INTERACT PRO
- Telcos - INTERACT PRO
- Processing Settings - INTERACT PRO
- Output Settings - INTERACT PRO
- Compliance
- Bookmarks
COMMUNICATIONS SETTINGS - INTERACTAT
Your INTERACT system can be controlled through the network or through serial connection. You
can also connect a PTZ camera to the Camera port and use the Voice Tracking feature (not
available on the INTERACT PRO).
Network Settings
Note: Contact a Network Administrator for information on current network settings
and permissions
Change IP Settings
1. Create a unique network name and enter it in the Network Name field. (Default is ClearOne.)
2. If your network is DHCP enabled, the IP Address, Subnet and Gateway information will be
filled in.
3. If your network is not DHCP-enabled or if you require a static IP address, clear the Use
DHCP check box and enter the IP, Subnet and Gateway addresses.
4. Select Use DNS if you have a Domain Name Server and want name resolution (to use a net-
work name) for your static IP address.
5. Set a User Name and Password for access when connecting over IP. The default user
name is: clearone. The default password is: interact - these are not case sensitive.
6. Click OK to save the settings and close the window.
Set Up IP Filtering
Enter specific IP addresses that will be allowed to access the INTERACT system.
IP filters allow you to restrict access to your INTERACT system. Only computers with the specified
IP address can connect to INTERACT. You can specify a range of IP addresses by using zeros.
For example, entering 192.168.105.0 will allow any IP addresses in the 192.168.105.1 to
192.168.105.254 range to access the INTERACT system.
Serial Port Settings (AT Only)
Configure Camera Port
1. If you are connecting a camera for voice tracking mode, set the Baud Rate to match the
baud rate indicated in the camera specifications.
2. Select Flow Control to enable hardware flow control.
3. Click OK to save settings and close the window.
Configure Control Port
1. Select the Control Port Baud Rate that matches the baud rate of the PC COM port or the con-
trol device.
2. Select Flow Control to enable hardware flow control.
3. Click OK to save settings and close the window.
- 31 -