User's Manual

INTERACT MIC AND MIC EX SETTINGS - INTERACT AT ONLY
Level
The Level tab lets a user adjust level settings for each of the INTERACT MIC's three microphones
independently.
l Fine Gain: Use the slider to adjust Fine Gain for each Mic Input independently
l Level Meter: Displays current levels for each Mic Input
l ALC: Click the ALC button to activate Auto Level Control for each Mic Input independently
l Mute: Click Mute to mute each input independently
l P Pwr(MICEX only): Click this button to enable Phantom Power for the mic channel.
Processing
The processing tab adds processing and filters to each microphone based on user preference.
l AEC: Click the AEC button to activate Acoustic Echo Cancellation
l NLP: Default is Soft. Click a radio button to set the Non-Linear Processing level or deactivate
the feature.
l NC: Click the NC button to activate/deactivate Noise Cancellation. Use the slider to adjust
the amount of noise cancellation used for that microphone.
l Speech Lift: Click the Speech Lift button to route the microphone’s audio to the Loud-
speaker output. Use the Speech Levelslider to set the desired level (the default is -6 dB).
l Filter: Click to apply filtering to each independent Mic Input.
o
Start by clicking Add Filter
o
Adjust the filter placement by moving the point along the grid (Hz, dB/deg).
n Alternatively, click Table View to apply a list view.
o
To adjust the active filter, click the fields along the top row.
n Active Filter: Selects the filter to adjust
n Type: Sets the type of filter applied
n Frequency: Adjusts the frequency of the filter
n Gain: Increases or decreases gain applied to the filter
n Q: Increases or decreases the Q applied to the filter
n Bandwidth: Adjusts the filter's bandwidth
n Bypass: Bypasses the filter completely
o
To add phasing to a filter, click Phase
o
Click Bypass Allto override all filter settings
o
Click Remove Filter to delete the selected filter
o
Click Close to apply settings and close the window
o
To remove an existing filter, open the Processing tab, click Remove Filter
and Close.
- 34 -